Rolling Steel Solid Doors
1
Model CG300 commercial quality
2
Model CG600 economy quality
3
Model Insulator R Value 8.7
4
Model CGDADE Miami Dade county approved
5
Model CG650 mini roll up doors
Commercial Coiling Grilles
6
Model MM10 architectural Coiling Grille
7
Model CG516 coiling grille retail quality
8
Model Perf Door ventilated doors
9
Model Eurogrille for beauty and strength
10
Model CGCS150 counter shutters
UL Classified Fire Rated Products
11
Model CGFD300 UL Classified coiling doors
12
Model CGFS150 fire rated counter shutters
13
Model CGFD300EZ with automatic EZ reset feature
14
Insulated & Fire Rated Coiling Doors
Door for Special Application
15
Side Folding Grilles
16
Folding Gates
17
European Shutters
18
Doc-Port Rolling Door for high stress wind loads
Motors
19
Motorize your Rolling Gates & Shutters.
20
Motor operators are integral power units engineered for long life and reliability.
   
 
Search:
Motor Operators - CGEXTERNAL
 

View pdf version of this page.

 
MOTOR OPERATORS
Motor operators offer the most efficient means of operation. They soon pay for themselves by conserving heat, by more efficient traffic flow, by savings in man- power. Further, for frequent or rapid use, remote controlled motor operators are mandatory.
 
Motor operators are integral power units engineered for long life and reliability. For each door or grille requirement, horsepower and gear reduction are designed conservatively.
 
STANDARD FEATURES
U.L. CLASSIFIED OPERATOR
INTERNAL PRE-WIRING TO TERMINAL BLOCK MOTOR
-high starting torque ball bearing
GEAR REDUCTION-worm gear in oil bath (Model M)
-chain sprocket gearing (Model H)
CONTROLLER-magnetic across-the-line reversing
BRAKE-solenoid actuated holding (Model M)
-mechanical self-locking (Model H)
CLUTCH-adjustable friction type (Model H)
EMERGENCY CHAIN OPERATOR-independent of motor SAFETY INTERLOCK-for chain operation
LIMIT SWITCH-geared chair, driven
OVERLOAD PROTECTION - NEMA 1 components CONTROL STATION - 3 button
TRANSFORMER-24 volt control circuit
 

OPERATOR MOUNTINGS (INTERIOR)+

VF mounting (vertical front-of-coil) is standard for Service doors and steel grilles up to approx. 270 sq. ft., and for all aluminum Grilles. VW mounting (vertical wall) is standard for larger steel doors and grilles, and for all Fire doors.

Optional mountings (HT, HS, HF) are available when in accord with good engineering practice.

+For doors mounted on exterior face of wall, with operators on exterior (i.e., types SEM & AEM), the VW mounting is applied

 
 

TYPICAL OPTIONAL EQUIPMENT

OPERATORS-explosion-proof, water-tite, dust-tite
MOTORS-enclosed, special voltages
STARTERS-explosion-proof, water-tite, dust-tite, combination with disconnect means
SAFETY EDGE BOTTOM BARS -electric or pneumatic
STATIONS -key-operated, explosion-proof, oil-tite, pull cord, pendant, weatherproof.
SAFETY EDGE BOTTOM BARS -electric or pneumatic
Torque limiters
Auxiliary limit switches
Timers, Treadles, Bell signals
Radio transmitters & receivers
Photo-electric controls, Loop detectors
Interlocks between pairs of doors
Interlocks as safety cut-out switches